Bathroom Fixture Adhesive
Bathroom Fixtures Adhesive has been created with cement, fine sand and special admixtures. It is used to bond and fill up vacuous spaces in tiles, stone materials, ceramic materials and glass for building construction.
Being thixotropic, Bathroom Fixtures Adhesion Remitar can be easily applied. With the appropriate consistency, it does not run down the surfaces of application and displays outstanding bonded strength. Therefore, this product is suitable as a bonding agent for tiles, stones and ceramic materials, etc.
In addition, with the superb water repellency and water proofing quality, Bathroom Fixtures Adhesion Remitar can also be used as a waterproof material to fill up various gaps and vacuous spaces. It is also outstanding in flexibility and anti-abrasion property, thus is highly durable and strong against impacts.
- Features
-
Application is simple because it only requires adding of water without having to mix sand and cement.
With outstanding adhesion, flexibility and anti-abrasion property, it prevents occurrence of cracks and falling off from the applied surface. As an anti-bacterial and anti-fungal product, it prevents generation of various germs and molds from the very source, thus creates hygienic environment.
With outstanding water repellency and detergency, it prevents occurrence of slime, thus maintains clean and hygienic environment.
- Use
-
- Bonding and filling of bathroom fixtures (toilet bowl, basin and bathtub, etc.) and repairing of joints
- Bonding of various building materials, such as tiles, stone materials and porcelain materials, etc. and filling of vacuous spaces
- Repairing cracks and gaps in bathroom, etc.
- Application Procedures
-
- Check for cracks, unevenness or existence of foreign substances, etc. in the areas to be bonded and filled. Then, thoroughly remove dust or foreign substances. (Partial crushing must be administered first in vacuous areas, joints and cracked parts.)
- Place the content from 1 bag (5kg) of Bathroom Fixtures Adhesion Remitar in an appropriately sized container. Add approximately 1.1ℓ of water and thoroughly mix for 5 minutes or more.
* 0.3ℓ for 1.5kg and 0.5ℓ for 2.5kg - Apply mixture in appropriate amount and thickness. Cleanly wipe Bathroom Fixtures Adhesion Remitar from the surfaces of bathroom fixtures with a sponge or cloth before it is cured in approximately 5 ~ 10 minutes.
- Avoid contact with water or impact exertion before the product is set.
- Caution
-
- It is advised to wear plastic or rubber gloves when handling the product.
- Make sure to maintain even ratio of water content in mixture to achieve satisfactory quality, such as even joint color, etc.
- Mixing in of other substances (cement or sand) rather than water may cause deterioration of quality.
- When handling product in low temperature, there is a possibility of freezing in the areas of application. Make sure the surrounding temperature is 5℃ or higher.
- Remitar mixed with water must be used within 1 hour.
- Store product in a dry indoor place. Once opened, the product must be used immediately.
- Store product away from children's reach.
|
Application area |
Approximately 1m2 [2.5mm in thickness (2kg/mm m2)] (based on 5kg) |
|---|---|
|
Solidification time |
Approximately 24 hours (based on temperature of 20℃ and humidity of 60%) |
- Inquiry
- Kum Byeong-Gi 82-2-531-7143 kimbk@hanil.com
